USB Serial Port (COM4) Driver Download For Windows 10

Posted By admin On 31/01/22

CH340 IC is a low cost USB to TTL converter IC. CH340g ICis used in low cost SMD Arduino UNO & Arduino Nano boards. Many USB to Serial converter IC’s are available in the market but this is a low cost IC that is gaining popularity. USB to TTL converter modules are also available based on this IC. Even Node MCU IOT modules also have this IC.

USB Serial Port Driver WINDOWS 10 X64 & X86 All Problem Solved - ORNOBTelecom Read Officeil Stock Rom Firmware File. Download drive.google.com Your video will.

You can download the Drivers for CH340g from below

Download CH340g Driver for windows 7, 8 and windows 10

To install serial ports and COM ports using these system-supplied components, do the following: Provide an INF file that specifies the Ports device setup class and the Serial function driver as the service for the port. To configure a serial port as COM port, comply with the requirements that are defined in Configuration of COM Ports. On mobile editions of Windows, such as Windows 10 Mobile, only drivers that are part of the operating system are loaded. Unlike desktop editions, it is not possible to load a driver through an external driver package. With the new in-box INF, Usbser.sys is automatically loaded if a USB-to-serial device is detected on the mobile device.

I have personally tested the above CH340 driver on windows 7 and it worked with the Arduino Nano, Node MCU and Arduino UNO clones.

Usb Serial Port (com4) Driver Download For Windows 10 32-bit

Usb

Step By Step Installation of CH340g Drivers

Initially connect your hardware having CH340 USB to Serial IC to your PC. In the device manager it will show “USB2.0-Serial” (as shown in below figure) which means your ch340 driver has not been installed.

Now extract the CH340g drivers in a folder and in that you will find folder named “CH341SER” in which there will be a “setup” application file as shown below.

Com

Open the setup file and a “Driver Setup” option will open. Just click on the install file.

This installation takes some time. In my laptop it took 1 minute so just have patience. Once installed it will show driver successfully installed. Now go again back to device manager and there you will see that the driver has been successfully been installed and a com port has been allotted. In below image you can see that “com19” has been allotted for ch340g IC in my laptop

Drivers for the ch340 IC has now been installed successfully. I have tested this drivers and installation process in Windows XP, windows 7. Will test is soon on Windows 8 & windows 10.

You can see in above image that Port Number 19 has been allocated to this IC. If you want you can even change the virtual com port number from Device Manager.

USB Serial Port (COM4) Driver Download For Windows 10

Usb serial port (com4) driver download for windows 10 pro

For MAC users you can check CH340 Installation Guide for MAC users

Please enable JavaScript to view the comments powered by Disqus.